129D-Link DIR-810L User ManualSection 5 - Connecting to a Wireless NetworkWPS/WCN 2.0The router supports Wi-Fi protection, referred to as WCN 2.0 in Windows Vista. The following instructions for setting this updepends on whether you are using Windows Vista to configure the router or third party software.When you first set up the router, Wi-Fi protection is disabled and unconfigured. To enjoy the benefits of Wi-Fi protection, therouter must be both enabled and configured. There are three basic methods to accomplish this: use Windows Vista’s built-insupport for WCN 2.0, use software provided by a third party, or manually configure.If you are running Windows Vista, log into the router and click the Enable checkbox in the Basic > Wireless section. Use theCurrent PIN that is displayed on the Advanced > Wi-Fi Protected Setup section or choose to click the Generate New PINbutton or Reset PIN to Default button.If you are using third party software to set up Wi-Fi Protection, carefully follow the directions. When you are finished, proceedto the next section to set up the newly-configured router.
