3ENglIShFig. 8Step 5: (Fig. 5)1. Slide the spreader impeller (9) onto the spreader shaftand secure it with a 1/8” x 1-1/2” cotter pin (30).Step 6: (Fig. 6)1. Place the hopper on the hopper support tubes, insertingthe spreader shaft through the square hole in thebottom of the hopper.2. Slide the hopper bushing (39) onto the spreader shaftand insert it into the bottom of the hopper.3. Slide the spacer (25) onto the spreader shaft.4. Install the agitator hairpin (31) in the spreader shaft.Step 7: (Fig. 7)1. Attach the hopper to the lower set of holes in thehopper support tubes using four 1/4” x 1-3/4” hex bolts(23), 1/4” washers (34), nylon washers (33) and 1/4”nylock nuts (32). Tighten.Step 8: (Fig. 8)1. Install the grip (42) onto the flow control arm.2. Assemble the adjustable stop (44) to the flow controlbracket using the 1/4” x 3/4” carriage bolt (24), nylonwasher (33) and wing nut (43). Tighten.Fig. 5Fig. 6Fig. 793031 2539 123323433 3433233232434233134424

Craftsman CMXGZBF7124571 Instruction Manual

Product

Learn More

Legal