Menu
Craftsman CMXEOCG322 Owner's Manual
                                                                                                    |
INSTALLATION STEP 2INSTALL THE HEADER BRACKETYou can attach the header bracket either to the wall above the garagedoor, or to the ceiling. Follow the instructions which will work best foryour particular requirements. Do not install the header bracket overdrywall. If installing into masonry, use concrete anchors (notprovided).WALL HEADER BRACKET INSTALLATION1. Center the bracket on the vertical centerline with the bottomedge of the bracket on the horizontal line as shown (with thearrow pointing toward the ceiling).2. Mark the vertical set of bracket holes. Drill 3/16" pilot holesand fasten the bracket securely to a structural support with thehardware provided.Lag Screws5/16"-9x1-5/8"Highest Point ofGarage Door TravelVerticalCenterlineof Garage DoorDoor Spring2x4StructuralSupportVerticalCenterlineof Garage DoorHeaderBracketHorizontalLineUPWall MountOptionalMounting HolesFigure 1Header WallGarage DoorCEILING HEADER BRACKET INSTALLATION1. Extend the vertical centerline onto the ceiling as shown.2. Center the bracket on the vertical mark, no more than 6"(15 cm) from the wall. Make sure the arrow is pointing awayfrom the wall. The bracket can be mounted flush against theceiling when clearance is minimal.3. Mark the side holes. Drill 3/16" pilot holes and fasten bracketsecurely to a structural support with the hardware provided.Lag Screws5/16"-9x1-5/8"DoorSpring6" (15 cm) MaximumHeaderBracketVerticalCenterlineof Garage DoorGarage DoorVertical Centerlineof Garage DoorUPCeiling Mounting HolesFigure 2Header WallFinished CeilingLag Screw5/16"-9x1-5/8"HARDWARE SHOWN ACTUAL SIZE14 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved