Craftsman 911 041 Operator's Manual

APPLICATIONSYou may use this tool for the following purposes:[] Portable charging of Craftsman EX and DieHard7.2 Volt - 24 Volt batteriesCAUTION: If at any point during the chargingprocess none of the LEDs are lit, remove the batterypack from the charger to avoid damaging theproduct. DO NOT insert another battery. Return thecharger and battery to your nearest service centerfor service or replacement.LED FUNCTIONS OF CHARGERLED WILL BE ON TO INDICATE STATUS OFCHARGER AND BATTERY PACK:[] Red LED on = Fast charging mode.[] Green LED on = Fully charged and in maintenancecharge mode.[] Green LED on = When battery pack is inserted intocharger, indicates hot battery pack or that battery packis out of normal temperature range.[] Yellow and Green LEDs on = Deeply discharged ordefective battery pack.[] No LED on = Defective charger or battery pack.CHARGING A COOL BATTERY PACKIf battery pack is below normal temperature range, thegreen LED on charger will come on. Allow battery pack toreach normal temperature, then the red LED will come on.NOTE: If the charger does not charge the battery packunder normal circumstances, return both the battery packand charger to your nearest Sears Repair Center forelectrical check.[] Charge the battery pack only with the charger provided.[] Make sure the power supply is normal householdvoltage, 120 V, 60 Hz, AC only.[] Connect the charger to the power supply.[] Place the battery pack in the charger aligning raised ribon the battery pack with the groove in the charger. SeeFigure 2.[] Press down on the battery pack to be sure contacts onthe battery pack engage properly with contacts in thecharger.[] Normally the red LED on charger will come on. Thisindicates the charger is in fast charging mode.[] Red LED should remain on for approximately 1 hourthen the green LED will come on. Green LED onindicates battery pack is fully charged and charger isin maintenance charge mode.NOTE: The green LED will remain on until the batterypack is removed from the charger or charger isdisconnected from the power supply.[] If both yellow and green LEDs come on, this indicatesa deeply discharged or defective battery pack. Allowthe battery pack to remain in the charger for 15 to 30minutes. When the battery pack reaches normalvoltage range, the red LED should come on. if the redLED does not come on after 30 minutes, this mayindicate a defective battery pack and should bereplaced.[] After normal usage, a minimum of 1 hour of chargingtime is required to fully recharge battery pack.[] The battery pack will become slightly warm to thetouch while charging. This is normal and does notindicate a problem.[] Do not place the charger and battery pack in an areaof extreme heat or cold. They will work best at normalroom temperature.NOTE: The charger and battery pack should be placedin a location where the temperature is more than 50°Fbut less than 100°F.[] When batteries become fully charged, unplug thecharger from power supply and remove the batterypack.BATTERYSHOWNCHARGING(BATTERYSOLDSEPARATELY)EVALUATING(YELLOW/ GREENLED)FULLYCHARGED(GREENLED)FASTCHARGE(RED LED)Fig. 2

/ 6

Related manuals for Craftsman 1425301