Craftsman 875.528280 Assembly And Operating Instructions Manual

WORKSHOP STOOLModel 875.618281 BlackModel 875.528280 BlueModel 875.528290 SilverModel 875.528300 GreenModel 875.528310 RedModel 875.528320 YellowOne-Year Full WarrantyFor one year from the date of purchase, ifthis Craftsman Workshop Stool fails due todefect in materials or workmanship, return itto any Sears store or other Craftsman outletin the United States for free repair or re-placement.This warranty gives you specific legal rights,and you may also have other rights that varyfrom state to state.Sears, Roebuck and Co., Dept. 817WA,Hoffman Estates, IL 60179SAFETY INSTRUCTIONS:WEAR SAFETY GLASSES when assem-bling this product.BE CAREFUL of possible sharp edges.DO NOT stand on this product. You mayfall which may cause personal injury.PARTSSee illustration on back of page.NOTE: The stool seat and backrest are pre-assembled prior to shipment.ASSEMBLY and OPERATIONINSTRUCTIONSFor assembly hex key (13) and a mini wrench (14)are supplied.1. Remove all parts from shipping carton. Remove allpackaging material from parts. Check partsagainst parts list before beginning assembly. If anyparts are missing, call 1-800-290-9054.2. Insert upper end of each backrest support bar (3)into backrest (1) so that one of the two springlocks snaps into place.Be sure to snap each support bar into backrest atsame height.3. Loosen lock knobs on underside of seat (2)enough so that you can insert the lower end ofeach support bar into the seat bracket. Insertsupport at least 4 inches to ensure seat stability.Tighten lock knobs securely.4. Unscrew nylon lock nuts (8) from socket head capscrews (5). Place cap screws through holes in topof leg connector (6). Invert connector and lay it onfloor. Position each leg (9) into connector so thatcap screw goes through leg hole. Place strengthplate (7) over legs so that cap screw goes throughhole in strength plate. Finger-tighten lock nuts,nylon ring up, onto ends of cap screws.5. Place square base (12) around legs. Remove locknuts from leg screws (11). Insert a leg screw intoeach corner of square and through hole in relatedleg. Finger-tighten lock nut. When all leg screwsand lock nuts are in place, securely tighten them.Then securely tighten the lock nuts on the strengthplate.6. Stand leg assembly upright. Insert air cylinder (4),white button up, through hole in top of leg connec-tor until cylinder comes to rest in the leg fixture (6)Part# 90000-06).7. Place seat on top of cylinder. Apply weight to seatto lock it to the cylinder. CAUTION: To avoid injury,be sure that seat is securely locked to cylinderbefore sitting on stool.8. Raise or lower seat by lifting up on the seatadjustment lever beneath seat. Lower the lever tolock seat at desired height.9. If necessary, you may adjust the leg feet (15)slightly so that the stool rests perfectly flat on thefloor. Do not unscrew the leg foot so far as tomake the connection between foot and leg un-stable.Sears, Roebuck and Co., Hoffman Estates, IL 60179 USAwww.craftsman.com

/ 5

Related manuals for Craftsman 875.528280