WARNINGWHEN ADDING FUELTurn generator OFF and let it cool at least 2 minutesbefore removing fuel cap. Loosen cap slowly to relievepressure in tank.Fill fuel tank outdoors.DO NOT overfill tank. Allow space for fuel expansion.Keep fuel away from sparks, open flames, pilot lights,heat, and other ignition sources.DO NOT light a cigarette or smoke._/HEN OPERATING EQUIPMENTDo not tip engine or equipment at angle which causesfuel to spill.This generator is not for use in mobile equipment ormarine applications._/HEN TRANSPORTING OR REPAIRING EQUIPMENTTransport/repair with fuel tank EMPTY or with fuel shutoffvalve OFF.Disconnect spark plug wire._/HEN STORING FUEL OR EQUIPMENT WITH FUEL INTANKStore away from furnaces, stoves, water heaters, clothesdryers or other appliances that have pilot light or otherignition source because they can ignite fuel vapors.WARNINGDO NOT touch hot surfaces.Allow equipment to cool before touching,CAUTIONDO NOT tamper with governed speed. Generatorsupplies correct rated frequency and voltage whenrunning at governed speed.DO NOT modify generator in any way.CAUTIONSee "Don't Overload Generator" on page 10.Start generator and let engine stabilize before connectinelectrical loads.Connect electrical loads in OFF position, then turn ONfor operation.Turn electrical loads OFF and disconnect from generatolbefore stopping generator.CAUTIONUse generator only for intended uses.If you have questions about intended use, ask dealer orcontact Sears.Operate generator only on level surfaces.DO NOT expose generator to excessive moisture, dust,dirt, or corrosive vapors.DO NOT insert any objects through cooling slots.If connected devices overheat, turn them off anddisconnect them from generator.Shut off generator if:-electrical output is lost;-equipment sparks, smokes, or emits flames;-unit vibrates excessively.4