Craftsman 486.245333 Owner's Manual

STEP6:(SEEFIGURE6)• Assemble the boom bars to the boom mount bracketusing two 5/16" x 1-1/4" carriage bolts (C), tooth lockwashers (J) (between the bar and bracket), 5/16" fiatwashers (G) and knobs (N). The boom connectinghose should extend upward.NOTE: Make sure the nozzles are adjusted so that theopenings face straight down when the boom bar is in thehorizontal operating position.BOOM CONNECTING HOSE --_..,,_//5116" FLATWASHER (G)KNOB (N) // WASHER (J) JLOCK)/BOOM BARCARRIAGE BOLT5/16" x 1-1/4" (C)FIGURE 6STEP 7: (SEE FIGURE 7)• Assemble the large (P) and small (O) spray' gun clipsto the side of the tank using two #10 x 1/2" screws(D) and #10 lock washers (I).STEP 8: (SEE FIGURE 8)• insert a garden hose gasket (T) into the swivel nut onthe bypass/return hose. Screw the nut onto the upperoutlet of the "Y" valve fitting. Place the other end ofthe hose down through the hole at the rear of thetank.• insert a garden hose gasket (T) into the swivel nut onthe boom connecting hose. Screw the nut onto thelower outlet of the "Y" valve fitting.• Slide the coiled hose clamp (S) onto the spray gunhose. Push the hose onto the hose adapter on theside of the "T" fitting as shown in figure 8. Tighten theclamp around the hose and the adapter. Snap thespray gun into the clips on the side of the tank.BYPASS/RETURN HOSESPRAYGUN COILEDHOSE HOSECLAMP (S)/BOOM CONNECTING HOSEFIGURE 8#10 x 318"SCREW (O)#10 LOCKWASHER (I)SPRAY GUNCLIP (P) (LARGE) SPRAY GUNFIGURE 7\\\ \