Craftsman 486.243201 Owner's Manual

Also see for 486.243201: Owner's manual

5FIGURE 5STEP 4: (SEE FIGURE 4)• Assemble the hitch bracket to the front tongue usingtwo 3/8" x 1" hex bolts (B) and 3/8" hex nylock nuts(L). Tighten.• Assemble the leg stand bracket to the front tongueusing two 5/16" x 1" hex bolts (C) and 5/16" nylocknuts (K). Tighten.FIGURE 3STEP 2: (SEE FIGURE 2)• Assemble the latch lock subassembly to the reartongue using two 1/4" x 1" hex bolts (E) and 1/4"nylock nuts (J). Tighten.• Assemble the plastic cap (O) to the front end of therear tongue.STEP 3: (SEE FIGURE 3)• Lay the rear tongue (open side facing up) onto theWheel Support. Assemble the axle through the wheelsupport and the second hole from the end of thetongue.FIGURE 2FRONTTONGUE(B) 3/8" x 1"HEX BOLT(L) 3/8" NYLOCK NUTHITCHBRACKETLEG STANDBRACKET(C) 5/16" x 1"HEX BOLT(K) 5/16" NYLOCK NUTFIGURE 4STEP 5: (SEE FIGURE 5)• Place the front tongue inside the rear tongue asshown in fi gure 5. Fasten the tongues together usinga 3/8" x 4" hex bolt (A) and a 3/8" nylock nut (L).Tighten, leaving the nut just loose enough that thetongues can pivot freely.• Insert the 3/8" x 4" clevis pin (G) through the tonguesand secure with a 1/8" hairpin cotter (M).LATCH LOCKSUB-ASSEMBLY(E) 1/4" x 1"HEX BOLT(J) 1/4" NYLOCK NUTREARTONGUE(O) PLASTIC CAPWHEELSUPPORTREARTONGUEAXLE FRONTTONGUE(L) 3/8"NYLOCK NUT(A) 3/8" x 4"HEX BOLT(G) 3/8" x 4"CLEVIS PIN(M) 1/8" HAIRPINCOTTER