Craftsman 45278 Operator's Manual

Hardware and other included contents can be found in thebottom drawer (unless otherwise noted).TOOLS REQUIRED:3/8" Wrench 1/2" Wrench5/16" Wrench ScissorsScrewdriverHardware included:(_ _ 10-24 x 5/16 Hex Screw(Qty: 24)1/4 - 20 x 1-1/2 Hex Screw (Qty: 4)(Included with Handle Pack.)5/16 - 18 x 1 Hex Screw (Qty: 16)(Only included with 36" Cabinet.)Cabinet:Handle Pack (Qty: 1)Caster packDrawer Liner Roll (Qty: 1)Drawer Dividers (Qty: 6) (for the 46" Cabinet, dividerscan be found in the top full length drawer.)LiteratureHardware bagHandle PackCaster Pack± .,$ TSIDE HANDLE INSTALLATIONItems Needed:1/4 - 20 x 1-1/2" Hex Screw (Qty: 4)Handle (Qty: 1)3/8" WrenchProcess:- Attach (1) handle endcap using (2) screws. Tighten witha wrench.Align handle with notches in attached endcap, hold inposition.Align notches in second handle endcap and attach using(2) screws. Tighten with a wrench.To remove, reverse the procedure.Screw HandleFigure 1CASTER INSTALLATION (if required)Items Needed:5/16-18 x 1 Hex Screw (Qty: 16)Caster Pack1/2" WrenchProcess:- Lay the cart down on its back. (Use packaging materialto protect the paint finish.)Mount both swivel casters on the same side of the cartusing (4) screws on each caster.Wrench tighten all screws.Mount rigid casters to the opposite end of the cart in thesame manner.Return the unit to its upright position.Drawer Liner RollDrawer DividerFigure 2