Craftsman 37634 Owner's Manual

MAKE CERTAIN THE DUST COLLECTOR ISDISCONNECTED FROM THE POWER SOURCE.Refer to Figure 9.Hose is attached to open end of dual inlet. To attach hose:1. Slide hose clamp onto free end of hose. Loosen clampscrew if required to slide hose clamp onto hose.2. Position the hose clamp wires on the hose grooves.3. Slide hose with clamp onto dual inlet.4. Tighten hose clamp screw to secure hose to dual inlet.ATTACH HANGERV!l, viv/,_l;1_,I I_[.€']lMAKE CERTAIN THE DUST COLLECTOR ISDISCONNECTED FROM THE POWER SOURCE.Refer to Figure 9.Hanger is fastened on the top side of housing assembly.To attach hanger:1. Place narrow end of lower hanger into hanger bracketand secure.2. Place narrow end of upper hanger into lower hangerand secure.ATTACH FILTER (TOP) BAGV!l,v_v/_,l;i _I I_[€-]lMAKE CERTAIN THE DUST COLLECTOR ISDISCONNECTED FROM THE POWER SOURCE.Refer to Figure 9.The filter bag is hooked onto the hanger and attached tothe housing. To attach filter bag:1. Hang the filter bag by the loop on the hanger hook.2. Slide the bag clamp into the loop on the bottom of thebag. Keep sliding the bag clamp until it comes out of theother side of the loop.3. Gently lift the clamp handle to release.4. Slide bag with clamp onto the opening on the housingtop.5. Secure bag to housing by positioning the spring con-nector into one of the slots on the latch and lock theclamp handle.6. Make sure top bag is secure.ATTACH COLLECTOR (BOTTOM) BAGV!VAv/_'I;I#I I_,[_e]lMAKE CERTAIN THE DUST COLLECTOR ISDISCONNECTED FROM THE POWER SOURCE.Refer to Figure 9.1. Slide bag with clamp on to the opening on the housingbottom.2. Position the spring connector into one of the slots onthe latch and lock the clamp handle.3. Make sure collector bag is secure.Filter BagBagClampBlower HousingAssemblyCla_,_,CollectorBagFigure 9 - Mounting Hose and BagsC_/_mp Hose12