Craftsman 351.223140 Operator's Manual

ATTACH INLETRefer to Figure 7.inlet needs to be attached to right side of dust collectorassembly. To attach inlet:• Position inlet over 2W' hole on right side of dust collectorassembly.• Secure inlet using four 4.2-1.4 x 12ram thread-formingscrews.Figure 7 - Attaching InletATTACH HOSERefer to Figure 8.Hose needs to be attached to the inlet using hose clamp.To attach hose:• Slide hose clamp onto one end of hose. Loosen clampscrew if required to slide hose clamp onto hose.• Position the hose clamp wires on the hose grooves.• Slide hose with clamp onto inlet.• Tighten hose clamp screw to secure hose with inlet.• Slide other hose clamp onto the opposite hose end. Thisend will be connected to the dust producing machineFigure 8 - Attaching HoseDANGER: Do not permit fingers to touch terminals of plugwhen installing or removing the plug to or from the outlet.WARNING: Do not connect to power source until unit iscompletely assembled.POWER SOURCE• Motor is designed for operation on the voltage and fre-quency specified on motor nameplate.• Normal loads will be handled safely on voltages not morethan 10% above or below the specified voltage.• Running unit on voltages not within range may cause over-heating and motor burnout.GROUNDING INSTRUCTIONSRefer to Figure 9.• This tool is equipped with a 3-conductor cord.• Do not remove or alter grounding prong in any manner. Inthe event of malfunction or breakdown, grounding providespath of least resistance for electrical current to reduce riskof electrical shock.• Plug must be plugged into a matching outlet that is proper-ly installed and grounded in accordance with all localcodes and ordinances.• The conductor with insulation having an outer surfacewhich is green is equipment grounding conductor. If repairor replacement is necessary, make sure equipmentgrounding conductor is not connected to line terminal.• If power cord is worn, cut or damaged in any way, have itreplaced immediately.Properly Grounded OutletGrounding Prong3-Prong Plug @I__Figure 9 - 3-Prong ReceptacleCAUTION: improper connection of the equipment-groundingconductor can result in a risk of electrical shock.EXTENSION CORDS• The use of any extension cord will cause some drop in thevoltage and loss of power.• Wires of the extension cord must be sufficient in size tocarry the current and maintain adequate voltage.• Use the table below to determine the minimum wire size(A.W.G.) extension cord.• Use only 3-wire extension cords having 3-prong groundingtype plugs and 3-pole receptacles which accept the toolplug.• If extension cord is worn, cut or damaged in any way, haveit replaced immediately.Extension Cord LengthWire Size A.W.G.Up to 50 ft ....................................... 16Note: Using extension cords over 50 ft. long is notrecommended.