Craftsman 351.223130 Operator's Manual

• If this system is used with other dust collectors, the dustcollector must be rated at least 3W' (of water) static pressureand 150 cfm at 2W' diameter. A reducer may be needed.• This system is not intended to be used with a wet/dry vac.DANGER:Do not use this dust collection system in aflammable or explosive atmosphere. Do not use to collectmetal shavings or dust Consult National Fire ProtectionAssociation (NFPA) standards before setting up a dust collec-tion system, especially NFPA 664.WARNING: Do not connect to dust collector until unit iscompletely assembled.CAUTION: improper connection of the equipment-groundingconductor can result in a risk of electrical shock.• Open blast gate of machine which will be used. Close allother blast gates.• Turn dust collector power switch to ON.• Turn woodworking machine power switch to ON.Refer to Figure 2.WARNING: Turn dust collector switch off and remove plugfrom power source outlet before maintaining your shop dustcollection system.Clean inside the pipes, fittings and flexible hose using a portablevacuum cleaner or manually remove large debris as needed.Model 351.223130Figure 2 - Replacement Parts Illustration forDust Collection System380© 27579KEYNO.1234567891011AAAPART NO.23967.0023968.0023969.0023970.0023971.0023972.6023973.0623974.6023975.6023976.6623977.0023964.6623961.61Not ShownDESCRIPTION2_/2x 24" Flexible HoseConnector45 ° Elbow - 2W'2_/2x 22" Plastic Straight PipeHanger2V2" Plastic "T" FittingBlast Gate2_/Z' Hose Clamp2_/2x 72" Flexible HoseMounting Hardware KitGrounding KitID/Warning LabelOperator's ManualQTY.1122483410411114