Craftsman 320.48277 Owner's Manual

3_ Press the Read key to turnon the laser beam; the laserindicator blinks (Fig 20).,4, Position the tool to aim thelaser at the target B5, Press the Read key todisplay the measured lengthof AB in the first row of thescreen (Fig. 21),6 The blinking line in "!'_."indicates the distance AC tobe measured.,7, Without changing themeasuring reference pointlocation of the too! inposition A, aim the laser dotperpendicularly to the target C8, Press the Read key again todisplay the calculated lengthof BC in the lowest row of thescreen; the distance AC willbe displayed at the same timein the second row (Fig.,22).9, Press the Read key to makea new measurement.,NOTES:The distance AC should beshorter than the hypotenuse(AB); otherwise the LCD willdisplay "Err008" remindingyou to re-measure thedistance ACFig, 20fI laser IFig 21f292t El. 011011 ftFi_ 22roDo= .o oKo onWhen taking the two measurements, make sure they are taken from thesame starting point (A) and the second measurement is perpendicular tothe target C. Taking the measurements correctly will help result in the mostaccurate calculated distance48277 ManuaLRevised_09-0211 Page t5