Craftsman 315.175111 Operator's Manual

Also see for 315.175101: Operator's manual

ADJUSTINGDEPTHOF CUTSeeFigures3,4, 5,and6,Werecommendthatcutsbemadeata depth notexceeding 1,/8 in, and that several passes be made toreach depths of cut greater than 1/8 in,[] Unplug your router,_ WARNING: Failure to unplug your router couldresult in accidental starting causing seriousinjury,[] Place router on a flat surface and loosen lockingarm, See Figure 3,[] Turn the depth indicator ring until the zero lines upwith the indicator point on the base, See Figure 5,LOCKING LOOSENARMFig, 3[] Turn depth adjusting ring until cutter is insidesubbase, See Figure 4,[] Turn depth adjusting ring until tip of cutter touchesflat surface,CUTTERAT ZERODEPTHOFCUT Fig, 5[] Position router so that the cutter can extend belowthe subbase for desired depth setting, SeeFigure 6,TORAISECUTTERTO LOWERCUTTERINDICATORPOINTCUTTERINSIDESUBBASE SUBBASEDEPTHADJUSTINGRINGDEPTHINDICATORRINGFig, 4[]CUTTEREXTENDEDBELOWSUBBASE Fig, 6Turn the depth adjusting ring to obtain the desireddepth of cut,NOTE: You can read the distance the cutter moveson the depth adjusting ring, Each major mark onthe depth adjusting ring indicates 1/32 inch changein depth setting, Each minor mark indicates ,0004in, The indicator point is located on the base,Tighten locking arm securely,10