Craftsman 315.114260 Operator's Manual

Also see for 315.114260: Operator's manual

Contents

10®CHARGERBATTERY PACKSHOWN IN CHARGERRED LED ON INDICATESFAST CHARGING MODEYELLOW AND GREEN LEDS ON INDICATES DEEPLYDISCHARGED OR DEFECTIVE BATTERY PACK.GREEN LED ON AFTER FAST CHARGINGCYCLE, INDICATES FULLY CHARGEDBATTERY PACK AND IN TRICKLECHARGE MODE.Fig. 24-1/2 in.FEATURESLED FUNCTIONS OF CHARGERLED WILL BE ON TO INDICATE STATUS OFCHARGER AND BATTERY PACK: Red LED on = Fast charging mode. Green LED on = Fully charged and in trickle chargemode. Green LED on = When battery pack is inserted intocharger, indicates hot battery pack or that battery packis out of or below normal temperature range. Yellow and Green LEDs on = Deeply discharged ordefective battery pack. No LED on = Defective charger or battery pack.CAUTION: To prevent damage to battery pack,remove battery pack from charger immediately if noLED comes on. Return battery pack and charger toyour nearest Sears Service Center for checking orreplacing. Also, if you are removing battery pack fromcharger and no LEDs are on, return both battery packand charger to your nearest Sears Service Center.Do not insert another battery pack into charger. Adamaged charger may damage a battery pack.IMPORTANT INFORMATION FOR RECHARGINGHOT BATTERY PACKWhen using your trim saw continuously, the batteries inyour battery pack will become hot. You should let a hotbattery pack cool down for approximately 30 minutesbefore attempting to recharge. When the battery packbecomes discharged and is hot, this will cause the greenLED to come on instead of the red LED. After 30 minutes,reinsert battery pack in charger. If green LED continues toremain on, return battery pack to your nearest SearsRepair Center for checking or replacing.Note: This situation only occurs when continuous use ofyour drill causes the batteries to become hot. It does notoccur under normal circumstances. Refer to "CHARGINGBATTERY PACK" for normal recharging of batteries. Ifthe charger does not charge your battery pack undernormal circumstances, return both the battery pack andcharger to your nearest Sears Repair Center for electricalcheck.IMPORTANT INFORMATION FOR RECHARGINGCOOL BATTERY PACKIf battery pack is below normal temperature range, thegreen LED on charger will come on. Allow battery pack toreach normal temperature, then the red LED will come on.Note: Refer to "CHARGING BATTERY PACK" fornormal recharging of batteries. If the charger does notcharge your battery pack under normal circumstances,return both the battery pack and charger to your nearestSears Repair Center for electrical check.minutes. When battery pack reaches normal voltagerange, red LED should come on.If red LED does not come on after 30 minutes, thisindicates a defective battery pack and should bereplaced. After normal usage, a minimum of 1 hour of chargingtime is required to fully recharge battery pack. The battery pack will become slightly warm to thetouch while charging. This is normal and does notindicate a problem. Do not place charger and battery pack in an area ofextreme heat or cold. It will work best at normal roomtemperature.Note: Charger and battery pack should be placed in alocation where the temperature is more than 50°F butless than 100°F. When batteries become fully charged, unplug chargerfrom power supply and remove the battery pack.