Craftsman 315.114010 Operator's Manual

Contents

Specifications

_ WARNING:Neverusea batterythathasbeendroppedor receiveda sharpblow.A damagedbatteryis subjecttoexplosion.Properlydisposeofadroppedbatteryimmediately.Failureto heedthiswarningcanresultin seriouspersonalinjury.• Before using battery charger, read all instructionsand cautionary markings in this manual, onbattery charger, and product using batterycharger. Following this rule will reduce the risk ofelectric shock, fire, or serious personal injury.• To reduce risk of injury, charge only nickel-cadmium type rechargeable batteries. Other typesof batteries may burst causing personal injury anddamage. Following this rule will reduce the risk ofelectric shock, fire, or serious personal injury.• Do not expose charger to wet or damp conditions.Following this rule will reduce the risk of electricshock, fire, or serious personal injury.• Use of an attachment not recommended or sold bythe battery charger manufacturer may result in arisk of fire, electric shock, or injury to persons.Following this rule will reduce the risk of electricshock, fire, or serious personal injury.• To reduce risk of damage to charger body andcord, pull by charger plug rather than cord whendisconnecting charger. Following this rule willreduce the risk of electric shock, fire, or seriouspersonal injury.• Make sure cord is located so that it will not bestepped on, tripped over, or otherwise subjectedto damage or stress. Following this rule will reducethe risk of serious personal injury.• Do not abuse cord. Never carry tool by cord oryank it to disconnect from receptacle. Keep cordfrom heat, oil and sharp edges. Following this rulewill reduce the risk of electric shock or fire.• An extension cord should not be used unlessabsolutely necessary. Use of improper extensioncord could result in a risk of fire and electric shock. Ifextension cord must be used, make sure:a. That pins on plug of extension cord are thesame number, size and shape as those ofplug on charger.b. That extension cord is properly wired and ingood electrical condition; andc. That wire size is large enough for AC ampererating of charger as specified below:Cord Length (Feet) 25' 50' 100'Cord Size (AWG) 16 16 16Note: AWG = American Wire Gage• Do not operate charger with a damaged cord orplug. If damaged, have replaced immediately by aqualified serviceman. Following this rule will reducethe risk of electric shock, fire, or serious personalinjury.• Do not operate charger if it has received a sharpblow, been dropped, or otherwise damaged in anyway; take it to a qualified serviceman. Following thisrule will reduce the risk of electric shock, fire, orserious personal injury.• Do not disassemble charger; take it to a qualifiedserviceman when service or repair is required.Incorrect reassembly may result in a risk of elec-tric shock or fire. Following this rule will reduce therisk of electric shock, fire, or serious personal injury.• To reduce the risk of electric shock, unplugcharger from outlet before attempting any mainte-nance or cleaning. Turning off controls will notreduce this risk. Following this rule will reduce therisk of electric shock, fire, or serious personal injury.• Disconnect charger from power supply when notin use. Following this rule will reduce the risk ofelectric shock, fire, or serious personal injury.• Save these instructions. Refer to them frequentlyand use them to instruct others who may use thistool. If you loan someone this tool, loan themthese instructions also. Following this rule willreduce the risk of electric shock, fire, or seriouspersonal injury.WARNING: Some dust created by power sanding,sawing, grinding, drilling, and other constructionactivities contains chemicals known to cause cancer,birth defects or other reproductive harm. Someexamples of these chemicals are:• lead from lead-based paints,• crystalline silica from bricks and cement andother masonry products, and• arsenic and chromium from chemically-treatedlumber.Your risk from these exposures varies, dependingon how often you do this type of work. To reduceyour exposure to these chemicals: work in a wellventilated area, and work with approved safetyequipment, such as those dust masks that arespecially designed to filter out microscopic particles.5