Craftsman 247.889720 Operator's Manual

Also see for 247.889720: Operator's manual

Contents

13ASSEMBLYChuteThe distance snow is thrown can be adjusted by changing the angle of the upperchute. To do so:1. Stop the engine by removing the ignition key and loosen the plastic wingknob found on the left side of the chute assembly.2. Pivot the chute upward or downward before retightening the wing knob.See Figure 14.Auger ControlWARNINGPrior to operating your snow thrower, carefully read and follow allinstructions below. Perform all adjustments to verify your snow thrower isoperating safely and properly.Check the adjustment of the auger control as follows:1. The auger control is located on the left handle. See Figure 15 inset.Whenthe auger control is released and in the disengaged “up” position, the cableshould have very little slack. It should NOT be tight.2. In a well-ventilated area, start the snow thrower engine. Refer to Startingthe Engine in the Operation section.3. While standing in the operator’s position (behind the snow thrower), engagethe auger.4. Allow the auger to remain engaged for approximately ten (10) secondsbefore releasing the auger control. Repeat this several times.5. With the auger control in the disengaged “up” position, walk to the front ofthe machine.6. To readjust the control cable, loosen the upper hex bolt on the auger cablebracket. See Figure 15.7. Position the bracket upward to provide more slack (or downward to increasecable tension).8. Retighten the upper hex bolt.9. Repeat steps 2-6 above to verify proper adjustment has been achieved.10. Confirm that the auger has completely stopped rotating and shows NO signsof motion. If the auger shows ANY signs of rotating, immediately return tothe operator’s position and shut off the engine. Wait for ALL moving parts tostop before adjusting the auger control.Figure 14Auger ControlFigure 15