Craftsman 247.772460 Operator's Manual

Also see for 247.772460: Operator's manual Operator's manual Parts list Operator's manual

18OFF-SEASON STORAGEPreParing THe edgerClean and lubricate edger thoroughly as described in the lubrica-•tion instructions.Do not use a pressure washer or garden hose to clean your unit.•Coat edger blade with chassis grease to prevent rusting.•Refer to• PREPARING THE ENGINE for correct engine storageinstructions.Store edger in a dry, clean area. Do not store next to corrosive•materials, such as fertilizer.when storing any type of power equipment in a poorly ventilated ormetal storage shed, care should be taken to rust-proof the equipment.Using a light oil or silicone, coat the equipment, especially cables andall moving parts of your edger before storage.WarningNever store edger with fuel in tank indoors or in poorly ventilatedareas where fuel fumes may reach an open flame, spark, or pilotlight as on a furnace, water heater, clothes dryer, or gas appliance.PreParing THe engineFor engines stored over 30 days:To prevent gum from forming in fuel system or on carburetor1.parts, run engine until it stops from lack of fuel or add a gasolineadditive to the gas in the tank. If you use a gas additive, run theengine for several minutes to circulate the additive through thecarburetor—after which the engine and fuel can be stored up to24 months.while engine is still warm, change the oil.2.Clean engine of surface debris.3.