Craftsman 247.770330 Operator's Manual

8ASSEMBLYAttaching The Hose Assembly1. Slide hose adapter of hose assembly into the base adapter located on the leftfront of the Yard Vacuum. See Figure 5.2. Pull spring loaded pin out on the base and align pin with the first hole(closest to the end of the tube) in the hose adapter.3. Release the pin to lock the hose in place.4. Snap the hose handle first into the upper hose handle bracket and then intothe lower hose handle bracket. See Figure 6.5. Lay hose tubing in curved end of handle next to chipper chute and into hosecradle.Attaching The Bag1. Grasp bag handle with one hand and slide locking rod on mounting bracketwith other hand toward engine. Use the end of mounting bracket as leveragewhen sliding the locking rod. See Figure 7.2. Slip bag over the rim of the discharge opening and release locking rod tosecure bag in place.3. Snap bag clip to the top of the lower handle.4. Place the lower straps on the bag over the top of lower handle, hooking themon the studs. See Figure 7.NOTE: The bag/chute switch button attached to the mounting bracket mustbe fully depressed by the tip of front tab on bag handle when securing thebag or engine will not start.12Align pinwith thishole.Figure 545Figure 64312Figure 7