Craftsman 247.24019 Operator's Manual

Also see for 247.24019: Operator's manual Operator's manual

11Assembling Remaining Bagger ComponentsNow that the mounting brackets are assembled and are in place onthe tractor, follow these steps to assemble the remaining baggercomponents.Snap the upper chute support in place by first clipping the side1.portion onto the bin support rail. Align the edge of the snapfeature with the red line (1), as shown in the inset of Fig. 13.Snap the front portion of the upper chute support to the bin2.support rail as seen in 2 of Fig. 13.Install the grass catcher cover screen into the bagger cover by3.first inserting the end closest to the side with the cutout into themounting hole, as in Fig. 14. Make sure to feed the screen underthe lip, as in Fig. 15.Clip in the other side by flexing the screen and pushing it down4.into the provided cutout hole. See Fig. 15.Install the grass catcher cover onto the bin support assembly, as5.seen in Fig. 16. The grass catcher cover goes inside of the twomounting tabs on the bin support assembly.Slide the hinge pin into the hole located on the mounting tab, as in6.Fig. 17 on the following page. Use the cut-out window (See insetin Fig. 17) to line up the hinge pin on the other side and push pinall the way in until it reaches the end-stop. At this point the pinclips into place and is secured by a tab in the bagger cover. SeeFig. 18.ASSEMBLY AnD InSTALLATIOn12Figure 13Figure 15Figure 16Make sure screen sitsunder the cover’s lipFigure 14