Craftsman 172.11810 Operator's Manual

TFORWARD / REVERSE SELECTOR SWITCH with POWER LOCK-OFF(Fig, 2, 2a, 2b)Fig, 2FORWARDFig° 2aREVERSEFig_ 2bPOWER LOCK-OFFThe direction of bit rotation is !orward or reverse and is controlted by a selector switchIocated above and to the rear of the trigger switch., When holding the dri|tlddver in thenormal operating position, (and viewed from the back of the driiI!driver see Figs, 2, 2aand 2b), the selector switch should be posilioned (pushed) a_l the way 1o the LEFT,for FORWARD or normal drilling I driving, and positioned (pushed) all the way to theRIGHT for REVERSE to remove ddll bits alld back out screws°The third position for lhs selector switch is lccaled in the CENTER (Fig, 2b) This position keepslhe trigger swilch Item working, locking the power"OFF Selling the selector switch in the "OFFor CENTER position helps reduce Ihe possibility of accidental starling when the tool is nol in use,l Z_ CAUTION: To prevent gear damage, ekvays altow the chuck to come to a ]complele stop before changing the direction of rotation.REMOVE BATTERY PACK FROMDRILL / DRIVER (Fig, 3)1, Place the Forward / Reverse Selector Switchwith Power Lock-Off into thecenter posttiontolock the power off (see Fig,2, above),,2 Locate the latches on each s_de of tile batlarypeck,,Depress (squeeze in) latches and pullbattery pack out o! drill,14