Menu
Craftsman 171.25490 Owner's Manual
                   |
For maximum accuracy, one edge of your workpiece(edge sliding againsl the fence)-rhust be true andslraight. Set up your fence as follows:1. Raise guard and rest it against the back o! thevacuum outlet.2. Position the fence behind tile rouler bit for the desiredcutting depth (the distance of the cut from the edge ofIhe workpiece, as shown in Figure 33).I3. Securely tighten both knobs and LOWER THEGUARD OVER THE BIT.4. Make the cut by sliding straight edge of workpieceagainst the fence. Use a push stick as shown inFigure 34. [For each successive cut, the fence wouldneed to be re-adjusted).NOTE: Test cut a piece of scrapwood before makingyour finish cut. Feed workpiece in the directionof arrow (Refer to Figure 34).iFIGURE 34USING ROUTER TABLE WITHOUT THE UNITIZEDFENCEWARNING: ROUTING WITHOUT THE UNITIZEDFENCE AND THUS THE GUARD COULD CAUSEACCIDENTS AND POSSIBLE PERSONAL INJURY,EXTREME CARE MUST BE TAKEN FOR THIS .*ROUTING OPERATION,ALWAYS UNPLUG THE ROUTER BEFORE MAKINGANY SETTING ADJUSTMENTS, OR CHANGING BITS.ALWAY@ FEED WORKPIECE AGAINST THEROTATION OF THE CUTTER.ONLY PILOTED ROUTER BITS ARE TO BE USED,MANY ROUTING APPLICATIONS (SUCH AS SHOWNIN FIGURE 35) WILL REQUIRE THE FENCE TO BEREMOVED FROM THE TABLE.Router CutDoorFIGURE 35If the workpiece I_eing cut is between _e cutter and theoperator, then feecl from RIGHT TO LEFT as shown inFigure 36.NOTE: When routing deep cuts (conlro_ed by router bit}in a workpiece, remove material in increments toprevent your muter from overloading. Repeatoperation wilh several passes until the desireddeplh is achieved.16FIGURE 36 |
Related manuals for Craftsman 171.25490
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved