Craftsman 152.213371 Owner's Manual

Fig. 13V//1, Align the four hobs in intake port (A) with themounting hobs in flange (B) of blower and motorassembly and fasten with four M4,2 sheet metalscrews (C), See figure 14,Fig. 150 08, Attach the lower dust bag retaining clip (V) to thedust collector drum, Align both hobs (W) in theretaining clip with the two hobs in the drum, inserta 1/4-20 x 5/8" hex head screw through each hobin the retaining clip and drum, Place a 1/4" fiatwasher and 1/4-20 hex nut onto screw inside of thedrum, Repeat this process for the other threeretaining clips and tighten all hardware,See figure 13,iNTAKE PORT TOBLOWER MOTOR ASSEMBLYMAKE CERTAIN THE DUST COLLECTORDISCONNECTED FROM THE POWER SOURCE.ED2, Attach one intake port cap (D) to the intake port (E),The intake port caps must be placed into the intakeports when the intakes are not in use,See figure 15,IMPORTANT: When connecting an intake hose to oneor both intake ports, DO NOT REMOVE THE INTAKEPORT CAP COLLARS (F} FROM THE INTAKEPORTS, Slide the collar further back when attaching ahose, See figure 15,Fig. 14BNLTER AND COLLECTION BAGTO DRUM ASSEMBLYMAKE CERTAIN THE DUST COLLECTOR ISDISCONNECTED FROM THE POWER SOURCE.A 1, Hook the loop (A) on the top filter bag onto hook(B) of the upper support rod, See figure 17,13