Craftsman 152.21152 Owner's Manual

AVAILABLE ACCESSORIESVisit your Sears Hardware Department or see the SearsPower and Hand Tool Catalog for the followingaccessories.ITEMReplacement grinding wheelsWire and Buffing wheelsSpacersWheel dressersUniversal standSTOCK NUMBERSee catalog or storeSee catalog or storeSee catalog or storeSee catalog or store9-22250Sears may recommend other accessories not listed inthis manual.See your nearest Sears Hardware Department or SearsPower and Hand Tool Catalog for other accessories.Do not use any accessory unless you have completelyread the Owner's Manual for that accessory.Use only accessories recommended for this BenchGrinder. Using other accessodes may be cause seriousinjury and cause damage to the Bench Grinder.UNPACKING AND CHECKINGCONTENTS (Fig. C)This Bench Grinder will require a minimal amount ofassembly. A 12mm x 10mm open end wrench is pro-vided for mounting the Tool Rest Assemblies and theSpark Arrestor Assemblies. A philips screwdriver is notprovided to mount the Wheel Dresser SupportRemove all of the parts from the shipping box and laythem on a clean work surface. Compare the items to(Fig. C), verify that all items are accounted for beforediscarding the shipping box.Fig. CIf any parts are missing, do not attempt to plug in thepower cord and turn "ON" the Bench Grinder. TheBench Grinder can only be turned "ON" after all theparts have been obtained and installed correctly.The following items are to be provided in the shipping box:A. GrinderB. Quench trayC. Wheel dresserD. Hex Wrench 12mm x 10mm open endE. Left Eyeshield assembly (not shown)F. Right Eyeshield assemblyG. Left tool rest assembly (not shown)H. Right tool rest assemblyI. Drill Bit Sharpening PlateDHAF6