Menu
Craftsman 139.53696 Manual
  |
CLOSEDOPENIndoor ReceiverAC AdapterTransmitterCR20323 VOLTSLithium Battery(CR2032 type) Double-Sided VelcroTo prevent possible SERIOUS INJURY or DEATH from a closing garagedoor:• Activate door ONLY when it can be seen clearly, is properly adjusted,and there are no obstructions to door travel.• ALWAYS keep garage door in sight until completely closed. NEVERpermit anyone to cross path of closing garage door.WARNINGCAUTIONWARNINGWARNINGOPEN DOOR MONITOR SYSTEMPRE-INSTALLATION SYSTEM TEST1. The transmitter and receiver are pre-matched (programmed)at the factory. Test the system by flipping the transmitter overwhile it is a few feet away from the receiver. The receiver willshow a green light for closed when the transmitter is face upin the vertical position with the round end of the case pointingdown (Figure 1). The red light will flash when the transmitter isface down in the horizontal position (Figure 2).2. If the green or the red receiver lights do not come on, or donot react as described, see the Troubleshooting or Learningsection of these instructions.Know when your garage door is open or closed !Thank you for purchasing the Craftsman Open Door Monitor.Monitor the status of your garage door from inside your home. Nolonger will you have to run downstairs or go outside just to see ifyou or your children have left the garage door open.INSTALLING THE BATTERY IN THE OPEN DOORINDICATOR TRANSMITTER1.Place the screw driver blade on the tabat the end of the case and gently pressdown and in toward the case.2. Insert the the lithium battery into thebattery clip with the + (positive) sideface up.3. Push the case back together tightly byinserting the top hooks into the backcover, then snap shut the bottom ofthe case.NOTE: It is normal to hear a rattle fromthe tilt switch in the Transmitter whentilted or rotated to another position.INDOOR RECEIVER SETUP1. Plug the AC adapter intoany standard 110 volt ACelectrical wall outlet and thesmall plug into the back ofthe Indoor Receiver.2. The Receiver has a 9 "antenna wire which comesout the back. The antennashould be straight and nottouching metal.3 VOLTSCLOSEDOPENAntenna LearnButtonACAdapterLocationFigure 1 Figure 2Inside of GarageDouble-Sided VelcroRoundEndDownMOUNTING THE TRANSMITTERAttach the transmitter to the inside of the garage door using thedouble-sided velcro. Mount the transmitter near the top of thegarage door for best results. The round end of the case shouldbe pointing down when the garage door is closed.Open Door MonitorModel 139.53696® |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved