Craftsman 11580 - C3 19.2 Volt Hammer Operator's Manual

Contents

A WARNING: Do not allow familiarity with tools tomake you careless. Remember that a carelessfraction of a second is sufficient to inflict seriousinjury.A WARNING: Always wear safety goggles or safetyglasses with side shields when operating tools.Failure to do so could result in objects being throwninto your eyes, resulting in possible serious injury.A WARNING: Do not use any attachments or acces-sories not recommended by the manufacturer ofthis tool. The use of attachments or accessories notrecommended can result in serious personal injury.APPLICATIONSYou may use this tool for the following purposes:[] Drilling in wood[] Drilling in ceramics, plastics, fiberglass, and laminates[] Drilling in metals[] Mixing paint[] Hammer drilling in concrete, brick, or other masonryThis product will accept DieHarde_ 19.2 V lithium-ion bat-tery packs and Craftsman 19.2 V nickel-cadmium batterypacks.For complete charging instructions, refer to the Operator'sManual for the battery packs and chargers listed in theGeneral Safety Rules.TO INSTALL BATTERY PACKSee Figure 3.m Lock switch trigger on the drill by placing the directionof rotation selector in the center position.m Place battery pack in the drill. Align raised rib onbattery pack with groove inside drill.CAUTION: When placing battery pack in the drill,be sure raised rib on battery pack aligns with grooveinside drill and latches snap into place properly.Improper assembly of battery pack can cause dam-age to internal components.[] Make sure the latches on each side of the battery packsnap in place and battery pack is secured in drill beforebeginning operation.TO REMOVE BATTERY PACKSee Figure 3.m Lock switch trigger on the drill by placing the directionof rotation selector in the center position.m Locate the latches on the side of the battery pack anddepress to release the battery pack from the drill.m Remove battery pack from the drill.LATCHESDEPRESSLATCHESTORELEASEBATTERYPACKFig. 310