Craftsman 113 Owner's Manual

Also see for 113: Owner's manual

Contents

b. Before tightening fence lock knob, hold fencedown on outfeed table so it does not rock.c. 90 ° Fence Stop positions fence square to tables.To tilt fence, loosen the two knobs and pull thestop out. Tilt to desired angle and tighten bothknobs.d. To set fence at 90 ° to tables, loosen the twoknobs, tilt fence so the stop springs back ifitoplace. Tilt fence back so the stop rests on the,13. FENCE TILT SCALE. Indicates the angle of thefence to the tables. When the 90 ° fence stop is cor-rectly adjusted, the fence will be 90 ° to the table andthe scale wil! read 90 °,To check for squareness, place an accurate square oninfeed table and check fence while locked at 90 °position. MAKE SURE 90 ° STOP IS AGAINSTSLIDE BRACKET.If fence is not square to table;a. Slightly loosen fence lock knob and guard lockknob.table and tighten both knobs.e. 45 ° Fence Stop positions the fence at 45 ° to thetables.f. To tilt fence to 45 ° loosen the two knobs, pufl90 ° stop out, tilt fence so the 45 ° stop rests on thetab{eg. Hold fence down on outfeed table and tighten thetwo knobs....-..-FENCE TILT SCALEFENCEFACESQUARE tNFEEDTABLECUTTERGUARDb,c_d.Loosen 90 ° stop screw with small screwdriver andturn knurled sleeve which will cause fence to tilt.Turn sleeve in either direction until fence is squarewith infeed table.NOTE: If you cannot square fence by turningknurled sleeve, loosen three screws "A" and adjustfence square to table.Tighten 90 ° stop Iockscrew and both fence lockknobs,If 90 ° reading on tilt scale does not line up withtop surface of the slide bracket, loosen screwsholding scale and move _t . , . tighten screws.450 STO_KNURLED _'_13SCALEADJUSTINGSCREWLOCKSCREW. TILT, SCALE_-"7.-.,._._ k" 90 ° STOPBRACKET