Craftsman 113.225705 Owner's Manual

Contents

CAUTION: To avoid injury from tool movement,supporting surface where spindle sander ismounted should be examined carefully aftermounting to insure no movement during use canresult_ If any tipping or walking is noticed, secureto workbench or supporting surface before operat-ing spindle sander.Bolting Spindle Sander To.WorkbenchIf Spindle sander isto be used in a permanent location, itshould be fastened securely to a firm supporting surfacesuch as a workbench. If mounting to a workbench, holesshould be drilled through supporting surface of the work-bench using dimensions as shown.1. The unit should be bolted securely using 1/4" screws,washers and hex nuts (not included). Screw lengthshould be 1-1/2" plus the thickness of thebench top.Locate and mark the holes where sander is to bemounted.Drill (4) 3/8" diameter holes through workbench,Place sander on workbench, aligning holes on basewith holes drilled in workbench.Insert (4) 1/4" diameter screws and washers andattach nuts securely.1,3.4.5.I CAUTION: To avoid injury from tool movement, uself4" diameter screws and nuts.Rubber Feet-IT flO •11-t/2"Front11__l! •17-1t8"8