Craftsman 113.213170 Owner's Manual

Contents

RE-INSTALLING THE CHUCK AND ARBORt. Clean thetapered surface on thearbor with a cleancloth. Make surethere are no foreignparticlesstick-ing to the surface. The slightest piece of dirt onthis surface will prevent the arbor from seatingproperly.This will cause the drillto "wobble."2. Slide arbor into spindle on drillpress.3. Push up on chuck/arbor assembly as you rotatethem. You will feel rectangular end of arbor slip_otoa notch in the spindle.WARNING: MAKE SURE THE RECTANGULAR ENDOF THE ARBOR HAS SLIPPED INTO THE NOTCHIN THE SPINDLE BEFORE GOING ON TO STEP 4.FAILURE TO FOLLOW THIS DIRECTION MAYALLOW THE CHUCK TO COME LOOSE DURINGOPERATION, FLY OUT, AND HIT THE OPERATOR.SPINDLEARBORCHUCKSLEEVECHUCKeDDY4. Unlock support lock and raise fable so its abouttwo (2) inchesbelow tip of chuck.5. Turn chuck sleeve clockwise and open jaws in* chuck'completely.6. Turn feed handles counterclockwise and forcechuck against table until arbor is secure.SUPPORTLOCKFEEDHANDLECHUCKCHUCKSLEEVE22