Craftsman 113.207910 Owner's Manual

oiTOOLS NEEDEDScrewdriver [medium)3!8-inch wrench 7/!6*inch wrenchUNPACKING AND CHECKING CONTENTSThis Craftsman welder is shipped complete in one carton.In order to facilitate packaging, certain items have beenremoved at the factory, and must be assembled whenreceived by the purchaser. Remove all items from the looseparts bag and identify them by referring to figure I. These"'Loose" parts are listed below and should be accounted forbefore discarding any packing material. (See figure 1.)! 2/4LOOSE PARTS LISTKey No.(Fig, !) Part I_ame1234Figure tSty.Welding Helmet {Partially assembled)., i ........ 1Owner's Manual: ...... , ...... ............... IHelmet band assembly ...................... 1Loose Parts Bag-Containing the following items:Electrode H01der ... : : .................... 1Ground c_amp. .................. . ... .... 1Receptacle ............. _....... .. ....... tScrew, Hex.-Hd., 1/4-20 x 3/4 in ............. tNut, Hex,, 1/4-26 ........................ tWasher, Rat, 17/64 in ....... :... _/.: ...... IL0ckwasher, t/4 in........................ IATTACHING ELECTRODE HOLDERTO ELECTRODE CABLE1. Grasp the electrode holder and locate the slotted-head,handle iocking screw near the mid-point of the insulatinghandle tube. (See figure 2.) Loosen this screwapproximate|,/two turns, until the handle can be slippedoff the electrode holder.2. Slide the handle off electrode holder and insert end ofelectrode cable assembly through the handle as shown in3.4..6.figure 2. The electrode cable is the one withapprox mately 1/2-inch of the insulation stripped fromOne end.Using a screwdriver, back out the stetted-head set screw,_ocated near the end of electrode holder until the end ofscrew does not protrude into the wire socket in the endof holder.Make sure the wire strands on stripped end of electrodecable have not been "fra,/ed', Twist together withfingers if necessary.Insert stripped end of electrode cable into the electrodeholder and tighten the slotted-head set screw firmly,Slide the handle back into place on electrode holder andposition it until the hote in handle is directly over thehead of handle locking screw. Tighten the screw justenough to secure the handle on electrode holder.ATTACHING THE GROUND CLAMPTO THE GROUND CABLEAttach the terminal on end of ground cable to theground clamp, at the hole near the nose of the clamp,with the 1/4-20 x 3/4-inch screw, !/4-20 nut, 17/64-inchflat washer and 1!4-inch lockwasher furnished in theloose parts bag. (See figure 3.)SCREWNUT \_,Figure 3GROUND CABLEDO NOT USETHESE HOLES2. Do not use either of the holes in hand!e ends of groundclamp.3. Tighten the screw firml,/ enough to insure good contactand prevent the cable termina! from s!ipping on theclamp.