Craftsman 113.170170 Owner's Manual

Wet NozzleTo pick up liquids off a smooth surface,use the 2-1/2" wet nozzle accessory sup-plied with your wet/dry vac. To use thisnozzle, simply attach the nozzle to theend of an extension wand.Connect a second extension wand to thefirst, and connect the 2ol/2" x 7' hose tothe extension wand.Liquids may be picked up by dragging thenozzle across the surface. The squeegeewill dry the surface as you vacuum.Replacement rubber for the squeegeenozzle may be obtained through SearsParts. If the rubber becomes worn, it maybe flipped over for use on the oppositeside or replaced. (Replacement servicepart #822256). To reverse or replace thesqueegee:1. Lay the wet nozzle on a flat surface withthe round inlet opening facing up andthe two latches close to you as shown.Latches_ Removabl_e _InsertNozzleody2. Using both hands, position each thumbon the removable insert, (below thelatches) and two fingers of each handon each latch, lift and disengage thetwo latches from the tabs on the nozzlebody.3. Gently pull the latches toward yourselfto remove the insert.To reinstall the removable insert correctly,follow these steps:1. Place the removable insert on a flat sur-face with the pins positioned upwardand the latches close to you as shown.Place the rubber squeegee on theinsert, with the pins fitting through thematching holes in the squeegee. (Makesure the new working edge is locatedfarthest from you.)2. Using both hands, lower the nozzlebody onto the insert and squeegee withthe round opening of the nozzle closestto you. With fingers on the far side andthumbs holding the latches of theremovabJeinsert, flip the nozzle over sothe latches are on the top and the roundinlet opening is facing away from you.Make sure the squeegee stays on theinsert pins.3. Press down with each thumb below thelatching tabs until you see and hear theremovable insert snap into the nozzlebody. Snap the latches over the lockingtabs into their original position.4. Inspect the pins of the insert to makesure they fit through the holes of thesqueegee and fit into the matching slotsin the nozzle body.NOTE: If the pins are out position, holdthe nozzle assembly with both handsand gently twist in opposite directions.The insert pins should snap intoproper position.Twist TwistBackward ForwardThe wet nozzle assembly is ready for wetpickup use.13