Cisco Unified Video Camera Installation Manual

Also see for Unified Communications Manager: Configuration guide

Cisco Unified Video Camera Installation• Cisco Unified Video Camera Overview, on page 1• Set Up Cisco Unified Video Camera, on page 1• Perform Camera Postinstallation Checks, on page 2• Camera Settings, on page 2Cisco Unified Video Camera OverviewThe Cisco Unified IP Phone 9951 and 9971 supports the add-on Cisco Unified Video Camera accessory.The Cisco Unified Video Camera connects to your Cisco Unified IP Phone and allows you to make apoint-to-point video call with another Cisco Unified IP Phone with a Cisco Unified Video Camera attached.If a Cisco Unified Video Camera is not attached to the phone, the phone can only receive one-way video.The Cisco Unified IP Phone 8961 does not support the Cisco Unified Video Camera and does not displayvideo.NoteSet Up Cisco Unified Video CameraTo configure the Cisco Unified Video Camera, you must perform the following configuration steps in CiscoUnified Communications Manager Administration.You can enable the parameters that are described in the following procedure in one of the following windows:• Phone Configuration window (Device > Phone)• Enterprise Phone Configuration window (System > Enterprise Phone Configuration)• Common Phone Profile window (Device > Device Settings > Common Phone Profile)Be sure to also check the corresponding Override Common Settings parameter in the configuration window.The Phone Configuration window is used for purposes of the procedure description.Cisco Unified Video Camera Installation1

/ 4

Related manuals for Cisco Unified Communications Manager