Cisco SPA112 \ Cisco SPA1221. Setup occurs in the web interface. To log into it, enter the gateway IP address in yourbrowser’s address bar. You can find the gateway IP address by connecting a phone to itand dialing ****110#. The default username and password are both admin.2. Open Voip>SIP and enter the following RTP port range:RTP Port Min: 1024RTP Port Max: 65455

Cisco SPA112 Setup Manual

quick start guide

before you begin

back panel

connecting the equipment

configuration and management of the ata

using the ivr for administration

mounting the ata

where to go from here

SPA112

Chapter 1: Getting Started with the Cisco SPA100 Series Phone Adapters

Before You Begin

Product Features

Connecting the Equipment

Overview of the Configuration Utility

Chapter 2: Quick Setup for Voice over IP Service

Chapter 3: Configuring the Network

Internet Settings

Network Service (SPA122 Only)

Network Settings for the LAN and DHCP Server (SPA122 Only)

Time Settings

Advanced Settings

MAC Address Clone (SPA122 Only)

VPN Passthrough (SPA122 Only)

VLAN

Port Forwarding (SPA122 Only)

Manually Adding Port Forwarding (SPA122 Only)

DMZ (SPA122 Only)

Chapter 4: Configuring Voice

Understanding Voice Port Operations

Optimizing Fax Completion Rates

Fax Troubleshooting

Configuring Dial Plans

Digit Sequences

Acceptance and Transmission of the Dialed Digits

Dial Plan Timer (Off-Hook Timer)

Interdigit Long Timer (Incomplete Entry Timer)

Resetting the Control Timers

Configuring Voice Settings

Voice System Settings

Voice Provisioning Settings

SIP Settings

Voice System Regional Settings

Line 1 and Line 2 Settings (PHONE1 and PHONE2)

Chapter 5: Administration Settings

Management

Web Access Management

TR-069

SNMP

Bonjour

Logging

Log Setting

Log Module

Diagnostics

Traceroute Test

Firmware Upgrade

Restore Configuration

System Information

Interface Information

Internet Status

Port Statistics

frequently asked questions

Mounting the ATA

Getting Started

getting started

Understanding Voice Service Operations

LED Status for RC

Configuration and Management of the ATA

Using the IVR for Administration

Elements of the User Interface

Quick Setup for Voice over IP Service

Configuring the Network

network settings for the lan and dhcp server (spa122 only)

Quality of Service (QoS) (SPA122 Only)

manually adding port forwarding (spa122 only)

dmz (spa122 only)

Configuring the Voice Settings

Information

System

Provisioning

Regional

line 1 and line 2 settings (phone port1 and phone)

user 1 and user

SSL/TLS Certificate

Client Certification

Administration Settings

web access management

user list (password management)

log setting

log viewer

Factory Defaults

Configuration Management

Reboot

Viewing the Status and Statistics

interface information

internet status

dhcp server information (spa122 only)

Interdigit Short Timer (Complete Entry Timer)

Introduction

Initial configuration

SPA112 Back Panel

Router

Check the operation of the SPA112

Internet Light

SPA122

Cisco SPA112 Setup Manual

Product

Learn More

Legal