Cisco SCE8000 Installing

Also see for SCE8000 GBE: Installation and configuration guide Quick start guide Installation and configuration guide Configuration guide Installation guide

C H A P T E R4-1Cisco SCE8000 10GBE Installation and Configuration GuideOL-21054-044Installing the Cisco SCE8000 ChassisRevised: November 8, 2010, OL-21054-04IntroductionThis chapter describes how to install a Cisco SCE8000 chassis.Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.Statement 1030Warning There is the danger of explosion if the battery is replaced incorrectly. The battery is not auser-serviceable part.Statement 1015Warning Class 1 laser product.Statement 1008Warning Because invisible laser radiation may be emitted from the aperture of the port when no cable isconnected, avoid exposure to laser radiation and do not stare into open apertures.Statement 1056Warning Blank faceplates and cover panels serve three important functions: they prevent exposure tohazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do notoperate the system unless all cards, faceplates, front covers, and rear covers are in place.Statement 1029Note Before you install, operate, or service the system, read the Regulatory Compliance and SafetyInformation for the Cisco SCE8000 Platform. This guide contains important safety information youshould know before working with the system.