Cisco ONS 15454 Install

Also see for ONS 15454: Procedure guide Troubleshooting guide Installation instructions Hardware installation guide Install

C H A P T E R1-1Cisco ONS 15454 Procedure Guide, Release 8.5.178-18537-011Install the Shelf and Backplane CableThis chapter provides procedures for installing the Cisco ONS 15454. For a summary of the tools andequipment required for installation, see the “Required Tools and Equipment” section on page 1-2.Before You BeginThis section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).1. NTP-A1 Unpack and Inspect the ONS 15454 Shelf Assembly, page 1-4—Complete this procedurebefore continuing with the “NTP-A2 Install the Shelf Assembly” procedure on page 1-5.2. NTP-A2 Install the Shelf Assembly, page 1-5—Complete this procedure to install the shelfassembly in a rack.3. NTP-A3 Open and Remove the Front Door, page 1-6—Complete this procedure to access theequipment before continuing with other procedures.4. NTP-A4 Remove the Backplane Covers, page 1-7—Complete this procedure to access thebackplane before continuing with other procedures.5. NTP-A5 Install the EIAs, page 1-8—Complete this procedure if you plan to install electrical cards.This procedure is a prerequisite to the “NTP-A9 Install the Electrical Card Cables on the Backplane”procedure on page 1-22.6. NTP-A6 Install the Power and Ground, page 1-9—Complete this procedure before continuing withthe “NTP-A7 Install the Fan-Tray Assembly” procedure on page 1-11.7. NTP-A7 Install the Fan-Tray Assembly, page 1-11—Complete this procedure to install the fan-trayassembly in the shelf.8. NTP-A119 Install the Alarm Expansion Panel, page 1-13—Complete this procedure if you areplanning to install the Alarm Interface Controller–International (AIC-I) card and want to increasethe number of alarm contacts provided by the AIC-I card.9. NTP-A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections, page 1-16—Completethis procedure as needed to set up wire-wrap pin connections.10. NTP-A120 Install an External Wire-Wrap Panel to the AEP, page 1-17—Complete this procedure toconnect an external wire-wrap panel to the alarm expansion panel (AEP).11. NTP-A9 Install the Electrical Card Cables on the Backplane, page 1-22—Complete this procedureif you plan to install electrical card cables.12. NTP-A10 Route Electrical Cables, page 1-23—Complete this procedure as needed to routeelectrical cables installed on the backplane.