Cisco NTP-E157 Change Card Settings

Also see for ONS 15600: Reference guide Troubleshooting guide Reference manual Reference manual Reference manual

Contents

before you begin

C H A P T E R11-1Cisco ONS 15600 Procedure Guide, R5.0February 200811Change Card SettingsThis chapter explains how to change transmission settings on cards in a Cisco ONS 15600.Before You BeginAs necessary, complete the “NTP-E57 Document Existing Provisioning” procedure on page 7-2.Before performing the following procedures, investigate all alarms and clear any trouble conditions.Refer to the Cisco ONS 15600 Troubleshooting Guide as necessary.This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).1. NTP-E157 Provision a Multirate PPM, page 11-2—Complete this procedure to provision a multiratepluggable port module (PPM), for the ASAP card. If a multirate PPM was preprovisioned, thisprocedure is unnecessary.2. NTP-E151 Provision an Optical Line Rate, page 11-3—Complete this procedure to provision theoptical line rate on a multirate PPM for the ASAP card. Single-rate PPMs do not need to beprovisioned.3. NTP-E150 Change the Optical Line Rate, page 11-4—As needed, complete this procedure to editoptical line rates for multirate PPMs on the ASAP card.4. NTP-E149 Delete Pluggable Port Modules, page 11-5—As needed, complete this procedure todelete PPMs for the ASAP card.5. NTP-E66 Modify Line and Status Thresholds for Optical Ports, page 11-6—As needed, completethis procedure to change line (drop) and threshold settings for all OC-N cards.6. NTP-E105 Change an Optical Port to SDH, page 11-12—As needed, complete this procedure tochange an optical port from SONET to SDH.7. NTP-E125 Change Card Service State, page 11-13—As needed, complete this procedure to changecard service state.