Cisco Meraki MT12 Installation Manual

Also see for Meraki MT12: Installation guide

MT12 Installation Guide - Water DetectionOverviewThe Cisco Meraki MT12 is a cloud-managed water leak detection sensor that is exceptionally simple to configure anddeploy due to its integration with the Meraki dashboard and the use of Bluetooth Low Energy technology. The MT familyeliminates the complex and costly setup required by traditional solutions by removing the limitations of placement ofthese sensors.Pre-Installation PreparationYou should complete the following steps before going on-site to perform an installation:Configure Your Network in the DashboardThe following is a brief overview of the steps required to add an MT12 to your network. For detailed instructions aboutcreating, configuring, and managing Meraki sensor networks, refer to the MT - Sensors online documentation.1. Log in to dashboard.meraki.com. If this is your first time, create a new account.2. Find the network to which you plan to add your sensor, or create a new network.3. Add the sensors to your network. You will need your Meraki order number (found on your invoice) or the serialnumber of each sensor, which looks like Qxxx-xxxx-xxxx, and can be found on the back of the unit or included inthe box.4. Add the gateway (MV or MR) to the same network as the sensor.WARNING:Make sure the gateway is in the same network and is online and operational. If the sensors are powered on without afunctioning gateway in the immediate vicinity, the sensors will consume power at a high rate until it finds a gateway.Click here for MV setup instructions and MR setup instructions.Quickly Scan and Claim Multiple Devices through the Meraki Mobile AppIf you have to claim multiple devices, the quickest way is by scanning their barcode using the Meraki app.1. Log in to your Meraki iOS or Android app with your Meraki dashboard account. Create a new account if you do nothave one.2. Navigate to the correct network through left-side bar.1