Cisco Firepower 4100 Series Maintenance And Upgrade Manual

Also see for Firepower 4100 Series: Product guide Hardware installation guide Command reference Hardware installation guide Manual

Maintenance and Upgrade• Install the Network Module, on page 1• Remove and Replace the Fan Module, on page 4• Remove and Replace the SSD, on page 5• Remove and Replace the Power Supply Module, on page 8• Connect the DC Power Supply Module, on page 10• Secure the Power Cord on the AC Power Supply Module, on page 16Install the Network ModuleTake note of the following warnings:Statement 60—UL- and CSA-Certified Equipment WarningThis card is intended to be installed in UL- and CSA-certified equipment in the field by the user in themanufacturer's defined operator access area. Check the equipment manufacturer to verify/confirm that yourequipment is suitable for user-installed application cards.WarningStatement 1029—Blank Faceplates and Cover PanelsBlank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltagesand currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt otherequipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless allcards, faceplates, front covers, and rear covers are in place.WarningStatement 1030—Equipment InstallationOnly trained and qualified personnel should be allowed to install, replace, or service this equipment.WarningMaintenance and Upgrade1