Cisco FAN-MOD-3 Technical Information

Also see for Catalyst 6513-E: Installation and verification manual

Contents

chassis and module power and heat values

D-1Catalyst 6500 Series Switches Installation GuideOL-5781-08A P P E N D I X DChassis and Module Power and Heat ValuesThis appendix provides the power and heat numbers for the Catalyst 6500 series chassis and modules.The following power requirements and heat dissipation tables are provided:• Chassis and fan trays—Table D-1• IP phones—Table D-2• Supervisor engines—Table D-3• Policy Feature Cards (PFCs)—Table D-4• Distributed Forwarding Cards (DFCs)—Table D-5• Switch fabric modules—Table D-6• 10-Gigabit Ethernet modules—Table D-7• Gigabit Ethernet modules—Table D-8• 10/100/1000 Ethernet modules—Table D-9• Fast Ethernet switching modules—Table D-10• 10/100 Ethernet switching modules—Table D-11• 10BASE Ethernet switching modules—Table D-12• FlexWAN and Enhanced FlexWAN modules—Table D-13• Service modules—Table D-14• Miscellaneous modules—Table D-15Unless otherwise noted, the information in the following tables is measured under fully loadedconditions (transceivers installed). Typical numbers are approximately 20 percent below the numberslisted in these tables.Note Module power is the output from the power supply (internal to the system). The AC-input power is theinput from the outlet to the power supply. The percentage difference between the two values is theefficiency of the power supply.