Cisco Explorer 4640HD Quick Reference Manual

Also see for Explorer 4640HD: User guide

POWERSELECTVOL+VOL-CH+CH-SETTINGSEXITINFOGUIDEExplorer 4652HDQuick Reference GuideCisco Explorer 4640HD, 4642HD, 4650HD,and 4652HD High-Definition Set-Tops20080814_Installer820IMPORTANT SAFETY INSTRUCTIONSNotice to InstallersThe servicing instructions in this notice are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions, unless you are qualified to do so.Note to System InstallerWARNINGTO PREVENT FIRE OR ELECTRIC SHOCK, DO NOTEXPOSE THIS UNIT TO RAIN OR MOISTURE.For this apparatus, the coaxial cable shield/screen shall begrounded as close as practical to the point of entry of the cableinto the building.For products sold in the US and Canada, thisreminder is provided to call the system installer's attention toArticle 820-93 and Article 820-100 of the NEC (or CanadianElectrical Code Part 1), which provides guidelines for propergrounding of the coaxial cable shield.This symbol is intended to alert you that uninsulated voltagewithin this product may have sufficient magnitude to causeelectric shock.Therefore, it is dangerous to make any kind ofcontact with any inside part of this product.Ce symbole a pour but d’alerter toute personne qu’un contactavec une pièce interne de ce produit, sous tension et non isolée,pourrait être suffisant pour provoquer un choc électrique. Il estdonc dangereux d’être en contact avec toute pièce interne dece produit.This symbol is intended to alert you of the presence of importantoperating and maintenance (servicing) instructions in the literatureaccompanying this product.Ce symbole a pour but de vous avertir qu’une documentationimportante sur le fonctionnement et l’entretien accompagne ce produit.CAUTION: To reduce the risk of electric shock, do not remove cover(or back). No user-serviceable parts inside. Refer servicing toqualified service personnel.1) Read these instructions.2) Keep these instructions.3) Heed all warnings.4) Follow all instructions.5) Do not use this apparatus near water.6) Clean only with dry cloth.7) Do not block any ventilation openings. Install in accordancewith the manufacturer’s instructions.8) Do not install near any heat sources such as radiators, heatregisters, stoves, or other apparatus (including amplifiers)that produce heat.9) Do not defeat the safety purpose of the polarized orgrounding-type plug. A polarized plug has two blades withone wider than the other. A grounding-type plug has twoblades and a third grounding prong. The wide blade or thethird prong are provided for your safety. If the providedplug does not fit into your outlet, consult an electrician forreplacement of the obsolete outlet.10) Protect the power cord from being walked on or pinchedparticularly at plugs, convenience receptacles, and the pointwhere they exit from the apparatus.11) Only use attachments/accessories specified by themanufacturer.12) Use only with the cart, stand, tripod, bracket, ortable specified by the manufacturer, or sold with theapparatus. When a cart is used, use caution whenmoving the cart/apparatus combination to avoid injury fromtip-over.13) Unplug this apparatus during lightning storms or whenunused for long periods of time.14) Refer all servicing to qualified service personnel. Servicingis required when the apparatus has been damaged in anyway, such as a power-supply cord or plug is damaged, liquidhas been spilled or objects have fallen into the apparatus,the apparatus has been exposed to rain or moisture, doesnot operate normally, or has been dropped.Power Source WarningA label on this product indicates the correct power source for this product.Operate this product only from an electrical outlet with the voltage andfrequency indicated on the product label. If you are uncertain of the type ofpower supply to your home or business, consult your service provider oryour local power company.The AC inlet on the unit must remain accessible and operable at all times.Ground the ProductWARNING: Avoid electric shock and fire hazard! If this productconnects to coaxial cable wiring, be sure the cable system is grounded(earthed). Grounding provides some protection against voltage surgesand built-up static charges.Handling Disposable BatteriesThis product may contain disposable batteries. Heed the following warningand follow the Safety and Disposal instructions below.WARNING: There is danger of explosion if the battery ismishandled or incorrectly replaced. Replace only with the same typeof battery. Do not disassemble it or attempt to recharge it outsidethe system. Do not crush, puncture, dispose of in fi re, short theexternal contacts, or expose to water or other liquids. Dispose ofthe battery in accordance with local regulations and instructionsfrom your service provider.Safety• Insert batteries correctly. There may be a risk of explosion if the batteriesare incorrectly inserted.• Do not attempt to recharge ‘disposable’ or ‘non-reusable’ batteries.• Please follow instructions provided for charging ‘rechargeable’ batteries.• Replace batteries with the same or equivalent type that we recommend.• Do not expose batteries to excessive heat (such as sunlight or fire).• Do not expose batteries to temperatures above 100°C (212°F).Disposal• The batteries may contain substances that could be harmful to theenvironment.• Recycle or dispose of batteries in accordance with the batterymanufacturer’s instructions and local/national disposal and recyclingregulations.• The batteries may contain perchlorate, a known hazardous substance,so special handling and disposal of this product might be necessary.For more information about perchlorate and best managementpractices for perchlorate-containing substance, see www.dtsc.ca.gov/hazardouswaste/perchlorateProvide Ventilation and Select a Location• Remove all packaging material before applying power to the product.• Do not place this apparatus on a bed, sofa, rug, or similar surface.• Do not place this apparatus on an unstable surface.• Do not install this apparatus in an enclosure, such as a bookcase or rack,unless the installation provides proper ventilation.• Do not place entertainment devices (such as VCRs or DVDs), lamps,books, vases with liquids, or other objects on top of this product.• Do not block ventilation openings.Protect from Exposure to Moisture and ForeignObjectsWARNING: Avoid electric shock and fire hazard! Do not exposethis product to dripping or splashing liquids, rain, or moisture. Objectsfilled with liquids, such as vases, should not be placed on this apparatus.WARNING: Avoid electric shock and fi re hazard! Unplugthis product before cleaning. Do not use a liquid cleaner or anaerosol cleaner. Do not use a magnetic/static cleaning device (dustremover) to clean this product.WARNING: Avoid electric shock and fire hazard! Neverpush objects through the openings in this product. Foreign objectscan cause electrical shorts that can result in electric shock or fi re.Cisco Explorer 4640HD, 4642HD, 4650HD, and 4652HDHigh-Definition Set-TopsModels: 4640HD, 4642HD, 4650HD, and 4652HDManufactured by:Cisco Systems, Inc.5030 Sugarloaf ParkwayLawrenceville, Georgia 30044 USATelephone: 770-236-1077Service WarningsWARNING: Avoid electric shock! Do not open the coverof this product. Opening or removing the cover may expose you todangerous voltages. If you open the cover, your warranty will bevoid. This product contains no user-serviceable parts.Check Product SafetyUpon completion of any service or repairs to this product, the servicetechnician must perform safety checks to determine that this product is inproper operating condition.Protect the Product When Moving ItAlways disconnect the power source when moving the apparatus orconnecting or disconnecting cables.20081112_Cable_SafetyUnited States FCC ComplianceThis device has been tested and found to comply with the limits for a ClassB digital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against such interference in aresidential installation. This equipment generates, uses, and can radiateradio frequency energy. If not installed and used in accordance with theinstructions, it may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment OFFand ON, the user is encouraged to try to correct the interference by one ormore of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.• Consult the service provider or an experienced radio/television technicianfor help.Any changes or modifications not expressly approved by Cisco Systems,Inc., could void the user’s authority to operate the equipment.The information shown in the FCC Declaration of Conformity paragraph belowis a requirement of the FCC and is intended to supply you with informationregarding the FCC approval of this device. The phone numbers listed arefor FCC-related questions only and not intended for questions regarding theconnection or operation for this device. Please contact your service providerfor any questions you may have regarding the operation or installation ofthis device.Declaration of ConformityThis device complies with Part 15 of FCC Rules. Operation is subject to thefollowing two conditions: 1) the device may not cause harmful interference,and 2) the device must accept any interference received, includinginterference that may cause undesired operation.AVC VIDEO LICENSEWith respect to each AVC/H.264 product, we are obligated to provide thefollowing notice:THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO LICENSE FORTHE PERSONAL AND NON-COMMERCIAL USE OF A CONSUMER TO (i) ENCODEVIDEO IN COMPLIANCE WITH THE AVC STANDARD (“AVC VIDEO”) AND/OR (ii)DECODE AVC VIDEO THAT WAS ENCODED BY A CONSUMER ENGAGED IN APERSONAL AND NON-COMMERCIAL ACTIVITY AND/OR WAS OBTAINED FROM AVIDEO PROVIDER LICENSED TO PROVIDE AVC VIDEO. NO LICENSE IS GRANTEDOR SHALL BE IMPLIED FOR ANY OTHER USE. ADDITIONAL INFORMATION MAY BEOBTAINED FROM MPEG LA, L.L.C. SEE HTTP://WWW.MPEGLA.COM.Accordingly, please be advised that service providers, content providers, andbroadcasters are required to obtain a separate use license from MPEG LAprior to any use of AVC/H.264 encoders and/or decoders.Macrovision Copyright NoticeThis product incorporates copyright protection technology that is protectedby U.S. patents and other intellectual property rights. Use of this copyrightprotection technology must be authorized by Macrovision, and isintended for home and other limited viewing uses only unless otherwiseauthorized by Macrovision. Reverse engineering or disassembly isprohibited.DisclaimerCisco Systems, Inc. assumes no responsibility for errors or omissions thatmay appear in this guide. We reserve the right to change this guide at anytime without notice.Outdoor Grounding SystemIf this product connects to an outdoor antenna or cable system, be surethe antenna or cable system is grounded (earthed). This provides someprotection against voltage surges and built-up static charges.Article 810 of the National Electric Code (NEC) ANSI/NFPA No. 70-1990,provides the following information:• Grounding of the mast and supporting structure• Grounding the lead-in wire to an antenna discharge unit• Size of the grounding conductors• Location of the antenna-discharge unit• Connection to grounding electrodes• Requirements for the grounding electrodes (see the following antennagrounding diagram as recommended by NEC ANSI/NFPA 70)WARNING: Avoid electric shock and fire hazard! Donot locate an outside antenna system in the vicinity of overheadpower lines or power circuits. Touching power lines or circuitsmight be fatal.Protect the Product from LightningIn addition to disconnecting the AC power from the wall outlet, disconnectthe signal inputs.Verify the Power Source from the On/Off PowerLightWhen the on/off power light is not illuminated, the apparatus may still beconnected to the power source. The light may go out when the apparatus isturned off, regardless of whether it is still plugged into an AC power source.Eliminate AC Mains OverloadsWARNING: Avoid electric shock and fi re hazard! Do notoverload AC mains, outlets, extension cords, or integral conveniencereceptacles. For products that require battery power or other powersources to operate them, refer to the operating instructions forthose products.T11518 Canada EMI RegulationThis Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la class B est conforme à la norme NMB-003du Canada.20081121 FCC StandardCisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco’s trademarks can be found atwww.cisco.com/go/trademarks.Manufactured under license from Dolby Laboratories. Dolby is a trademark of Dolby Laboratories.HDMI, the HDMI logo, and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.Macrovision is a registered trademark of Macrovision Corp.MoCA is a trademark of the Multimedia over Coax Alliance.Other third party trademarks mentioned are the property of their respective owners.The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1005R)©2009-2010 Cisco Systems, Inc. All rights reserved.August 2010 Printed in United States of America Part Number 4029078 Rev BCisco Systems, Inc. 678.277.10005030 Sugarloaf Parkway, Box 465447Lawrenceville, GA 30042 www.cisco.com

/ 2

Related manuals for Cisco Explorer 4640HD