Cisco 2600 Series Installation Manual

Also see for 2600 Series: Hardware installation guide Configuration guide Hardware installation guide Manual Software configuration guide

Contents

1Doc. No.Cisco Systems, Inc.All rights reserved.170 West Tasman DriveSan Jose, CA 95134-1706USACisco Systems, Inc.Corporate HeadquartersCopyright © 1998Installing the Cisco RPS Adapter Platein Cisco 2600 Series RoutersProduct Number: ACS-2600RPS=This document describes how to install an adapter plate in Cisco 2600 series routers for use with theCisco Redundant Power System (RPS). The Cisco RPS provides power system redundancy toexternal devices (such as routers, switches, or hubs). The system includes two fully redundant ACinput power modules and four DC output power modules for connection to external devices. TheCisco RPS supports quasi-redundant and fully redundant power source configurations. To use theCisco RPS with Cisco 2600 series routers, you must remove the existing power supply and replaceit with a Cisco RPS adapter plate.This document includes the following sections:• Safety Recommendations on page 1• Required Tools and Equipment on page 4• Removing the Cover on page 5• Removing the Power Supply on page 7• Installing the Redundant Power Supply Adapter Plate on page 8• Obtaining Service and Support on page 11• Cisco Connection Online on page 11• Ordering Documentation on page 12Safety RecommendationsFollow these guidelines to ensure general safety:• Keep the chassis area clear and dust-free during and after installation.• Put the removed chassis cover in a safe place.78-5172-01