Cisco 2504 Getting Started Manual

Also see for 2500 Series: Manual Installing guide Getting started guide Configuration guide User guide

Americas Headquarters:Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USACisco 2500 Series Wireless ControllerGetting Started GuideFirst Published: May 2011About This GuideThis guide is designed to help y192.0.2.1ou install and minimally configure your Cisco 2504 WirelessController (2504 controller), which is part of the Cisco 2500 Series Wireless Controllers.FCC Safety Compliance StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuantto Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interferenceto radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which canbe determined by turning the equipment off and on.Try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help. (cfr reference 15.105)Safety InformationSafety warnings appear throughout this guide in procedures that may harm you if performed incorrectly.A warning symbol precedes each warning statement. The warnings below are general warnings that areapplicable to the entire guide. Translated versions of the safety warnings in this guide are provided in