Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor Hardware Installation Manual

C H A P T E R2-1Cisco ONS 15530 Hardware Installation GuideOL-7706-012Installing the Cisco ONS 15530This chapter describes the installation procedures for the Cisco ONS 15530 chassis and its components.This chapter includes the following sections:• Before Installing, page 2-1• Chassis-Lifting Guidelines, page 2-2• Rack-Mounting the Shelf, page 2-4• Grounding the Shelf, page 2-14• Installing and Removing Line Cards or Motherboards, page 2-17• Installing and Removing Modules, page 2-24• Replacing the Fan Assembly, page 2-27• Power Guidelines, page 2-29• Powering Up the Shelf, page 2-31Note Before you install, operate, or service the system, read the Regulatory Compliance and SafetyInformation for the Cisco ONS 15500 Series for important safety information you should know beforeworking with the system.Note To ensure that your Cisco IOS software release supports your hardware, see the “New and ChangedInformation” section on page vii. Also refer to the “Hardware Supported” section of the latest releasenotes for the Cisco ONS 15530.Before InstallingBefore you install the Cisco ONS 15530, you must complete the following tasks:• Unpack and inspect the shelf.• Maintain a network record.• Assemble required tools and equipment.• Mount the shelf.