Canon imagePROGRAF iPF8300 Basic Guide No.3 Basic Manual

Also see for imagePROGRAF iPF8300: Brochure Troubleshooting guide Troubleshooting guide Brochure Setup guide

Contents

Canon imagePROGRAF iPF8300 Basic Guide No.3 Basic Manual Manual pdf 2 page image

2It is not possible to prepare the printer for transfer if the Display Screen requests you to replace the MaintenanceCartridge or check the remaining capacity. Replace the Maintenance Cartridge before transfer preparations.(→ , Replacing the Maintenance Cartridge)•Depending on the state of the printer, part replacement may be necessary when preparing to transfer the printer(that is, when you execute the printer menu item to prepare for transfer).•Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and damagethe printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.•Ink must be drained before Level 2 or Level 3 printer transfer, as described in the following table. Prepare aMaintenance Cartridge in advance.•Always follow the instructions of the service representative when transferring the printer under Level 3 conditions.•To protect the internal parts in transit, always follow these steps before transferring the printer to a new location.Refer to the Setup Guide for details on packing the printer and installing it after transfer.Preparing to Transfer the PrinterPrepare to transfer the printer as follows.Level Shipping Method(Example)Amount of Ink toDispose of1 By truck 032Tipping the printer orholding it upright forelevators or stairsBy planeApprox. 1.9 L (64.2 fl oz)Approx. 600 ml (20.3 fl oz)RequiredMaintenanceCartridges(*1)0 or 12 or 31 or 2Permitted Angle of InclinationLengthwise: 0–30ºLengthwise: 0–90ºAll directions: 0–30ºRotation: 0–10ºRotation: 0–30º*1: The quantity of cartridges required depends on the capacity of the Maintenance Cartridge in use.