Canon imagePROGRAF iPF825 Basic Guide No.3 Basic Manual

Also see for imagePROGRAF iPF815: Technical documents Brochure Basic guide Basic guide Setup guide

Contents

Canon imagePROGRAF iPF825 Basic Guide No.3 Basic Manual Manual pdf 2 page image

2It is not possible to prepare the printer for transfer if the Display Screen requests Maintenance Cartridgereplacement or checking of the remaining capacity. Replace the Maintenance Cartridge before transferpreparations. (→ , Replacing the Maintenance Cartridge)•Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and damagethe printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.•Ink must be drained before Level 2 or Level 3 printer transfer, as described in the following table. Prepare aMaintenance Cartridge in advance.•Depending on the state of the printer, part replacement may be necessary when preparing to transfer the printer(that is, when you execute the printer menu item to prepare for transfer).•Always follow the instructions of the service representative when transferring the printer under Level 3 conditions.•To protect the internal parts in transit, always follow the steps below before transferring the printer to a newlocation. Refer to the Setup Guide for details on packing the printer and installing it after transfer.Level Permitted Angle of InclinationRequiredMaintenanceCartridges(*1)Shipping Method(Example)Amount of Inkto Dispose of1 By truck Lengthwise: 0°–30° 0 0 or 13 Tipping the printer orholding it upright forelevators or stairsLengthwise: 0°–90°2 By plane All directions: 0°–30°Approx. 700 mlApprox. 200 ml2 or 31 or 2Rotation: 0°–10°Rotation: 0°–30°*1: The quantity of maintenance cartridges required depends on the capacity of the Maintenance Cartridge in use.Preparing to Transfer the PrinterPrepare to transfer the printer as follows.