PaprWidth MismatchPaprWidth MismatchCause Corrective ActionWhen Detect Mismatch in the Control Panel menu is set toPause or Hold Job, the width of the loaded roll does notmatch the width specified in Fit Roll Paper Width in the print-er driver.Press ▲ or ▼ to select Print, and then press the OK button to resume print-ing.However, note that this error may cause paper jams and affect the printingquality.Press ▲ or ▼ to select Stop Printing, and then press the OK button.Follow these steps to replace the roll to match the width specified in the printerdriver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") →P.540(See "Removing Rolls From the Roll Holder.") →P.5422. Replace with paper of the width configured in the printer driver.(See "Loading Rolls on the Roll Holder.") →P.533(See "Loading Rolls in the Printer.") →P.536The printer now starts printing the print job.Make sure the roll width selected in the dialog box displayed when you selectFit Roll Paper Width in the printer driver matches the width of the roll loadedin the printer, and then try printing again.Paper size not detected.Paper size not detected.Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. Press the OK button and reload the paper.(See "Loading Rolls in the Printer.") →P.536(See "Loading Sheets in the Feed Slot.")→P.557If "Not finished printing. Finish printing re-maining jobs?" is displayed on the DisplayScreen, press the OK button.Printing will resume, starting from the page onwhich the error occurred.If this error recurs after you reload the roll, re-move the Roll Holder from the printer, push theroll firmly in until it touches the Roll Holderflange, and reload the Roll Holder in the print-er.(See "Loading Rolls on the Roll Holder.")→P.533Insufficient paper for jobInsufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount of roll paper left whenManageRemainRoll in the Control Panel menu is On.Press ▲ or ▼ to select Print, and then press the OKbutton to resume printing.However, the roll paper may run out during the print joband you may not be able to print all of the document.Press ▲ or ▼ to select Change Paper, and then pressthe OK button.Change the Paper Source of the printer driver, or re-place the roll with a roll that has enough paper for theprint job, and then print.(See "Removing the Roll from the Printer.") →P.540(See "Loading Rolls in the Printer.") →P.536PaprWidth Mismatch iPF6450User's GuideError Message Messages regarding paper1012
