Remove paper1 Disassemble and repackage the Stacker by following the installation procedure in reverse.Note• When storing the Stacker cable, place it in the cablepackage (or in a box measuring at least 30 cm (11.81in) per side) without folding.2 Remove the paper.• Rolls (See "Removing the Roll from the Printer.") ➔P.21• Sheets (See "Removing Sheets.") ➔P.28Access the Prep.MovePrinter menu1 If a message instructing you to replace the Maintenance Cartridge is displayed on the Display Screen, re-place the Maintenance Cartridge.(See "Replacing the Maintenance Cartridge.") ➔P.542 On the Tab Selection screen of the Control Panel, press ◀ or▶ to select the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.3 Press the OK button.The Set./Adj. Menu is displayed.4 Press ▲ or ▼ to select Prep.MovePrinter, and then press the OK button.5 Press ▲ or ▼ to select the level of transfer, and then press the OK button.Displays the confirmation screen.6 Press ▲ or ▼ to select Execute, and then press the OK button.The printer is now prepared for transfer.• Level 1Once preparations are finished, a message on the Display Screen requests you to turn off the printer.Turn off and pack the printer. There is no need to remove the ink tanks.(See "Pack the printer.") ➔P.90• Level 2 and Level 3When the preparation is finished, instructions are displayed on the Display Screen.iPF850 Series Preparing to Transfer the PrinterBasic GuidePrinter Relocation Preparing to Transfer the Printer87
