Canon iPF760 series Service Manual

Also see for iPF750 series: Service manual Service manual

Contents

Canon iPF760 series Service Manual Manual pdf 82 page image

Chapter 11-681.7.2 Other Precautions1.7.2.1 Printhead 0020-1924iPF765 / iPF760 / iPF750 / iPF7551. How to Handle the PrintheadDo not open the printhead package until you are ready to install the head.When installing the printhead in the printer, hold the knob and then remove the protective cap 1 and protective cap 2 in that order.Do not reattach the protective cap to the printhead because the cap may damage the nozzles.To prevent the nozzles from getting clogged with foreign matter or dried ink, install the printhead immediately after you remove the protective caps.Also make sure to press down the locking lever of the printhead until you feel a click.In addition, to prevent clogging of the nozzles with foreign matter and improper supply of ink, never touch the nozzles or ink port, or wipe it with tissue paper oranything else.Do not touch Electriacl contact.Also, never attempt to disassemble/reassemble the printhead or wash it with water.MEMO:If the nozzles are clogged or an ink suction problem occurs, white lines can appear on the printout a constant frequency or color dulling can occur. If this problemis not resolved by cleaning operations, replace the printhead with a new one.F-1-442. CappingThe printer will perform the capping operation when printing has ended or during standby due to an error, in order to protect the printhead and avoid ink leakage.If the power cord is accidentally unplugged, turn off the Power button, reconnect the power cord, and then turn on the Power button. Confirm that the printer startsup properly and enters to the "Online" or "Offline" status, and then power off the printer using the Power button.Improper "capping operation" may cause clogged nozzles due to dried ink or ink leakage from the printhead.3. When the printer is not used for a long timeKeep the printhead installed in the printer even when it is not used for an extended period of time.If the printhead is left uninstalled, a printing failure may arise from closed nozzles due to depositing of foreign matter or dried ink when it is reinstalled.Even if the head remains installed, the nozzle may dry out and cause a printing failure if the ink is drained for transport.4. Conductivity of InkThe ink used in this printer is electrically conductive. If ink leaks to into the mechanical unit, wipe clean with a soft, well-wrung damp cloth. If ink leaks ontoelectrical units, wipe them completely using tissue paper. If you cannot remove ink completely, replace the electrical units with new ones.If electrical units are powered with ink leaked onto them, the units may damage.Never connect the power cord when ink has leaded onto the electrical units.[1] Knob [4] Nozzles[2] Protective cap 1 [5] Electrical contact[3] Protective cap 2 [6] Ink port[6][5][4][3][2][1]