Canon WFT-E9 Advanced User's Manual

Responding to Error MessagesIf transmitter errors are displayed on the camera's LCD monitor, refer to the examples ofcorrective actions in this section to eliminate the cause of the error. When an error hasoccurred, the < > lamp on the transmitter blinks and the error code number is shownon the LCD panel. The error details can also be checked in the menu [ : Networksettings]→[Error description].Click the error code number in the following table to jump to the corresponding page.11 1221 22 2341 43 44 45 46 47 4861 63 64 65 66 67 68 6971 72 7382 839111: Connection target not foundIf you are using [EOS Utility], is EOS Utility running?• Start EOS Utility and re-establish the connection ( ).Are the transmitter and the access point set to use the same encryption key forauthentication?• This error occurs if the encryption keys do not match when the authenticationmethod for encryption is set to [Open system].The encryption key is case-sensitive. Make sure to enter the correct encryption keyfor authentication on the transmitter by verifying the uppercase and lowercaseletters used in it ( ).12: Connection target not foundAre the target device and access point turned on?• Turn on the target device and the access point, then wait a while. If a connection stillcannot be established, perform the procedures to establish the connection again.21: No address assigned by DHCP serverWhat to check on the transmitterOn the transmitter, the IP address is set to [Auto setting]. Is this the correctsetting?• If no DHCP server is used, configure settings after setting the IP addresses to[Manual setting] on the transmitter ( ).178