76(1) [LAN]LAN interface, maximum packet size settings (p. 47)(2) [IPv4]IP address, IPv4 settings, etc. (p. 47)(3) [IPv6]Settings regarding IPv6 (p. 48)(4) [Installation Conditions]Dome setting (p. 54)(5) [HTTP Server]Authentication method, HTTP, and HTTPS portsettings (p. 61)[Reboot Item] Setting Items Requiring RebootingThe following settings that require rebooting beforechanges take effect can be found on a single page.• LAN, IPv4, IPv6, Installation Conditions (VB-H41only), HTTP ServerImportantThese settings relate to network connectivity. If any setting ischanged to a value that may disable camera connection fromthe active web browser, a dialog box appears and alerts theuser.Click [OK] to apply the new setting.Depending on the new setting, it may not be possible toconnect to the camera again after rebooting. If this happens, acandidate URI for reconnecting the camera will appear ifavailable.Try the URI displayed to reconnect the camera.If you cannot connect to the camera through the displayed URI,contact your System Administrator.* Settings related to network connectivity in the [Reboot Item] menuare [LAN Interface], [Maximum Packet Size], [IPv4 AddressSetting Method], [IPv4 Address], [Subnet Mask], [IPv4 DefaultGateway Address], [AutoIP], [IPv6], [Auto (RA)], [Auto(DHCPv6)], [IPv6 Address (Manual)], [Prefix Length], [IPv6Default Gateway Address], [HTTP Port] and [HTTPS Port].
